Elitegroup MD100/MD110 (V1.0) Manual Manual do Utilizador descarregar pdf (Página 16)

Installing the Motherboard

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is

labeled.

Jumper Settings

1. To avoid the system instability after clearing CMOS, we recommend

users to enter the main BIOS setting page to “Load Default Settings”

and then “Save & Exit Setup”.

2. Make sure the power supply provides enough 5VSB voltage before

selecting the 5VSB function.

3. It is required that users place the USBPWR_R cap onto 2-3 pin rather

than 1-2 pin as default if you want to wake up the computer by USB/PS2

KB/Mouse.

Jumper Type Description Setting (default)

CLR_CMOS

3-pin

CLEAR CMOS

1-2: NORMAL

2-3: CLEAR CMOS

Before clearing the

CMOS, make sure to

turn the system off.

3-pin

1-2: VCC5

2-3: 5VSB

USBPWR_R

CLR_CMOS

Rear Panel

USB/PS2

Power Select

Jumper

USBPWR_R

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 44 45

Sem comentários

Elitegroup MD100/MD110 (V1.0) Manual Manual do Utilizador Página 16